At Therapy Limited Iron-On Heat Tape For NRX - Heat-Activated Bonding

Ships from Auckland, New Zealand. Health Wholesale is an Australian company, but this product is held in stock and dispatched from Auckland, so there are no international shipping delays or customs charges. Free shipping within New Zealand.

Intended for use by a trained practitioner, this tape requires heat at 120–140°C to activate its adhesive.

At Therapy Limited Iron-On Heat Tape for NRX bonds NRX materials together without sewing. Designed for therapists who prefer not to sew, it uses heat-activated glue applied with an iron or heat press.

Features

• Heat-activated adhesive for bonding NRX materials.
• 22mm wide tape supplied on a 10m roll.
• Recommended adhesive activation temperature: 120–140°C.
• Approximate setting time of 10 seconds.
• Suitable for application with an iron or heat press.
• Available in black only.

Suitable For

• Therapists joining NRX materials during fabrication.
• Bonding NRX materials as an alternative to sewing.

Usage Notes

Cut the two pieces of material you want to bond and place them side by side on a protective silicone baking sheet or baking paper. Cut the heat tape to the required length, allowing extra length beyond the bonding surface as it may shrink during heating. Position the tape over the join and cover the tape and material with another silicone baking sheet or baking paper.

Use an iron or heat press set to 120–140°C. Do not use the steam function on an iron. Apply heat for about 10 seconds, then check the bond and extend the heating time if needed.

For a strong bond, repeat the process on the reverse side.